Our services

Inline turnkey projects

Case 1 : cleaning laminate floor moulding plates.

This is normaly cleaned with chemicals and is very labor intensive. Production problems occurs wenn the brilliance aspect differs over the moulding surface. This leads to brilliance differences in the laminate product . Chemical cleaning,brushing and polishing are difficult to master on these Cr-Ni surfaces. With laser cleaning you can overcome a lot of production problems. Our laser systems are designed to clean these moulding plates. 


Left : view on the production moulding. Right : microscope view not cleaned/laser cleaned.


Left : view on the test plate in our lab. Right : gloss measurement before and after laser cleaning.


View on the gloss result after laser cleaning (right side).


View on the gantry laser cleaning installation.

Case 2 : cleanroom laser cleaning.

Contamination is building up on aluminium proces drums. Chemical cleaning is required every shift to keep up with the production cycle.

For saftey reasons and proces improvement they want to look for other cleaning technics. Laser cleaning was chosen.


View on the lab setup with robot for simulation.


Left : contamination before cleaning. Right : after laser cleaning.


Left : simulation laser 2D head configuration with side mirror. Right : global cleanroom laser proces housing.


Left : detail on laser head. Right : view on laser axis system and proces drum to clean.

Case 3 : wire cleaning.

Prior to plastification the wire surface must be cleaned. Laser cleaning is a solution.


View on the laser cleaned part (right).


Laser wire test device on the left. Right : surface tension test before and after laser cleaning.

go back